Back to: Wax

Plastic round wax melter with steam generator


Availability:
SKU: 3918
Diameter 46 cm, height 55 cm. This melter is entirely made of thermo plastic. It is intended for melting comb wax to be worked into pure wax. Wax cappings obtained during uncapping can also be melted. The melter works with steam generator (included).

Plastic round wax melter

Diameter 46 cm, height 55 cm. This melter is entirely made of thermo plastic. It is intended for melting comb wax to be worked into pure wax. Wax cappings obtained during uncapping can also be melted. The melter works with steam generator (included). When it is heated to the boiling point, it becomes vapour, which escapes through the perforated basket and melts the comb wax. Pure beewax than flows out through the perforated bottom of the wax melter. Simultaneosly the frames are disinfected. It is also possible to heat the melter with hard fuels.

When filling and emptying water from the device, the device must be turned off electricity. Because of the risk of burning with hot steam, it is always 2 minutes before Open the upper screw to wait. The appliance is automatically switched off when water is low turn off. If this happens, fill the cold water immediately and the device automatically turns on again. Complete evaporation of water should be prevented and eliminated eg using the switching clock. In case of failure, turn off the generator, check quantity water, check that the hose leading the steam is not clogged, check power supply. The height of the plastic container is 55 cm. The inside height under the lid is 52. The lower inner diameter is 38 cm and the upper inner diameter is 46 cm. A plastic electric wax meler is used to position frames. It is made of heat-resistant plastic. To plastic containers can be placed 12 to 15 frames of size 39x24 or 20 seams. The plastic container can be replaced with polystyrene extensions in which there are cladding normally hinged or at home produced by an insulated chamber with a maximum volume of two extensions 39x24 or three low frame extensions.

To speed up and improve wax extraction is great to insulate the plastic container with a blanket, foam or felt. Plastic wax melter place the oblique on the raised area. Under the outlet, place the container on running wax. Push the steam supply hose into the hole approximately 1/3 containers. Wax begins to run out after 30 minutes. Steam is also perfectly sterilized frames.

Made in Germany.

Reviews

There are yet no reviews for this product.

Please log in to write a review. Log in