info@beeequipment.eu

Select your language

Log in / Register
Log in / Register
My Wishlist

Your wishlist is empty.

Compare

No items are added to compare.

Cart

Your shopping cart is currently empty.

Candles mold FS112

10,90 €
excluding VAT:9,01 €
In stock
SKU: FS112
lyson-logo
My Wishlist
Compare

Silicone molds for beeswax candles type - FS112


The silicone mold is used for casting beeswax candles. The molds are made of high-quality silicone that can easily withstand the temperature of melted wax. Silicone molds are usually made from a single piece that is slit to allow easy removal of the candle. The slit in the mold also serves for inserting the wick. The molds are designed for repeated use.

Silicone molds are suitable for casting wax, soap, plaster, resin, etc.

How to make beeswax candles.

Before the first use, or if the mold has not been used for a long time, wash it. Silicone oil may be released, which needs to be washed off, for example with spring water, or wiped with a cloth soaked in alcohol.

Do not forget to secure the wick properly. To hold the mold together, use a simple rubber band, which is supplied with the mold. If needed, use more rubber bands. Round rubber bands are not suitable, as they tend to slide down on conical molds. For larger molds, rubber bands are not suitable, and it is better to use string wrapped around the mold several times, or stretch wrap film.

Heat the beeswax in a water bath and pour it into the mold when fully melted, approximately at a temperature of 65–70 °C. Adjust the procedure according to the wax used and the manufacturer's instructions. As the wax cools in the mold, its volume shrinks. At the same time, the wax tends to adhere to the edges of the mold as it solidifies. The final shape of the candle is therefore somewhat dependent on the flexibility of the mold material. It may help to pierce the center of the mold during solidification and subsequently top up the hole with more wax.

Sometimes there may be a problem if the mold has cavities and it is a very complex mold. Due to wax shrinkage, the volume decreases in these areas. The result is unfilled protruding parts. You can solve this problem by pre-filling these parts with a small amount of wax first.